GTI L4-2.0L Turbo (CBFA) (2008)
-
Insert a screwdriver - A - between protective housing and retaining plate - arrow -.
-
Pry protective housing upward using screwdriver - A - and pull it off sideways from retaining plate - arrow -.
-
Disengage forward harness connector - 1 - from ECM and disconnect it.
-
Pry up locking mechanism - 2 - slightly.
-
Then slide ECM out of retainer - arrow -.
-
Now disengage rear harness connector from ECM and disconnect it.
Installing
-
Connect rear harness connector to ECM and engage it.
-
Slide ECM on to retaining plate.
-
Now connect front harness connector to ECM and engage it.
-
Slide protective housing on to retaining plate.