GTI L4-2.0L Turbo (CBFA) (2008)
Clutch Switch: Service and Repair
Clutch Position Sensor (GTI) - 02Q, 6 Speed M/T FWD
Special tools, testers and auxiliary items required
^
Hose Clamps up to 25 mm dia. 3094
Removing
-
First check whether a coded radio is installed. In this case, find out anti-theft coding.
-
Disconnect battery Ground (GND) cable with ignition switched off.
-
Remove entire air filter housing, if it is located in the vicinity of the battery.
-
Remove battery and battery carrier.
If a hose/line assembly or plastic line -1- with a round component is installed directly below the master cylinder, hose/line assembly or plastic line
must be removed.
Note: While performing the following work, make sure that no brake fluid comes into contact with longitudinal member or with transmission. If this
happens, these areas must be cleaned thoroughly.
-
Clamp off the supply hose to the master cylinder using a Hose Clamps up to 25 mm dia. 3094.