GTI L4-2.0L Turbo (CBFA) (2008)
Clutch Pedal Assembly: Procedures
Pedal Cluster Assembly Overview (GTI) - 02Q, 6 Speed M/T FWD
1 - Cross Panel
^
With mount for mounting bracket
2 - Gasket
^
Always replace
^
Between mounting bracket and cross panel
^
Self-adhesive
^
Glue on mounting bracket
3 - Mounting bracket
^
For mounting of clutch pedal
^
Some equipment versions have a damper
4 - Bolt
5 - Over-center spring
6 - Bushing
7 - Pivot pin
8 - Clutch pedal
9 - Base block
^
To remove and install master cylinder, separate from clutch pedal.
10 - Gasket
^
Always replace
^
Between master cylinder and mounting bracket
11 - Master cylinder
12 - Clutch Position Sensor G476
^
Can be tested in "Guided Fault Finding" with the vehicle diagnostic, testing and information system VAS 5051.
^
In "Guided Fault Finding", the Clutch Position Sensor G476 is designated as the Clutch Pedal Switch F36.
13 - Clip
^
To remove and install the hose/line assembly or plastic line, pull the clip out to the stop
14 - Supply hose
15 - Self-locking nut, 25 Nm