GTI L4-2.0L Turbo (CCTA) (2009)
WARNING: The steps above must be completed to ensure safety during repair. Also, observe all country-specific regulations.
Use the applicable repair manual in Elsa in addition to the description below. Check ETKA to determine if you need set 1 or set 2.
-
Lengthen wires and preassemble seals according to Figure 1.
-
Release lock on new wiring harness end connector housing using small flathead screwdriver. Use slot marked in Figure 2.
-
Insert all terminals into housing until they audibly click.
-
Reinstall lock.
-
Using an appropriate assembly tool, slide the single wire seal up repair wire until it contacts housing. Continue to slide seal into housing as far as
the stop (Figure 3).