GTI V6-2.8L (BDF) (2002)
For replacement part carrier assembly, gearing is secured against slipping and falling by a cable tie -1-.
-
Slide a hammer handle between window guide and SF so far until hammer handle end presses on gears of SF.
-
Remove cable tie -1-.
-
By removing window regulator motor, gearing shifts, it is not centered.
-
When installing window regulator motor, gears must be aligned until window regulator motor is centered again.
-
Attach and tighten bolts -1-.
Tightening torque: 3.5 Nm
Tightening torque must always be observed since otherwise damage to plastic sleeve on window regulator motor can result.