GTI V6-2.8L (BDF) (2002)
Trunk / Liftgate Latch: Service and Repair
Rear Lid Lock, Removing And Installing
1
-
Locking clamp
2
-
Handle
-
Removing
- Unclip lid trim (handle is secured with a bolt).
- Unclip pull lever, pry out locking clamp and remove lock cylinder housing from handle.
- Disconnect connector for luggage compartment light and unclip operating rod for central locking system if necessary.
- Remove Torx bolts and remove handle from lid.
3
-
Actuator securing bolt
-
Loosen and tighten using Socket wrench T10010
4
-
Central locking actuator
-
Removing
- Disconnect connector from actuator.
- Remove actuator using Socket wrench T10010 and remove from lid.
5
-
Pull lever
6
-
Torx screw
7
-
Operating rod
8
-
Lock cylinder housing
-
Removing
- Unclip lid trim (handle is secured with a bolt).
- Unclip pull lever, pry out locking clamp and remove lock cylinder housing from handle.
9
-
Lock
-
Removing
- Remove lid trim.
- Disconnect connector from lock.
- Unclip operating rod , remove bolt and remove lock from lid.