GTI V6-2792cc 2.8L DOHC (AAA) (1996)
After-Run Coolant Pump: Testing and Inspection
LEGEND
1
Thermostat Housing
2
Bolt
3
Thermostat
4
Connection
5
Bolt
6
O-ring
7
Connection
8
Plug
Or
8
A/C Cut-Out Thermal Switch And Third Speed Fan Control Thermal Switch
9
After-Run Coolant Fan Control Thermal Switch With Engine Coolant Temperature Sensor.
10
Engine Coolant Temperature Sensor
11
Retaining Clip
NOTE: During testing procedures, refer to the component location illustration above and component notes below.
COMPONENT NOTES
Bolt (2)
-
Tighten to: 10 Nm (7 ft. lbs.).
Thermostat (3)
-
Checking, submerge thermostat in heated water and observe as follows:
-
Opening begins at approx: 80°C (176°F).
-
Opening ends at approx: 105°C (221°F).
-
Opening stroke, minimum: 7 mm (0.2800 inches)
Bolt (5)
-
Tighten to: 10 Nm (7 ft. lbs.).
O-ring (6)
-
Always replace.
Plug (8)
-
For models without A/C.