GTI V6-2792cc 2.8L DOHC (AAA) (1996)
Water Pump: Service and Repair
Coolant Pump, removing and installing
Removing
-
With ignition switched off, disconnect battery ground cable.
NOTE:
Obtain the radio anti-theft code from the customer before disconnecting the battery.
-
Disconnect exhaust pipe from the flange on the three-way catalyst See: Exhaust System/Exhaust Pipe/Service and Repair
-
Drain coolant See: Service and Repair
-
Remove ribbed drive belt See: Engine/Drive Belts, Mounts, Brackets and Accessories/Ribbed Belt/Service and Repair
-
Remove intake air duct
-
Disconnect spark plug cables from ignition coil and unclip from the cable guide -2-.
-
Remove the high tension wiring guide -2-
-
Disconnect vacuum hose between upper intake manifold and fuel pressure regulator
-
Remove intake air temperature sensor from upper intake manifold
-
Detach coolant expansion tank and place to side; hoses remain connected.
-
Fit engine support bracket tool No. 10-222 A with adapter tool No. 10-222A/3, or equivalent.
-
Locate support bracket in lifting eyes on left and right of cylinder head and take up weight of engine.