GTI V6-2792cc 2.8L DOHC (AAA) (1996)
/Page-798003.png)
-
Connect VAG 1598/18 test box to ECM wiring harness (arrow).
-
Check wiring between test box and 4-pin connector for open circuit according to wiring diagram.
-
Terminal 2 and test box socket 16.
-
Terminal 4 and test box socket 17.
Resistance: max. 1.5 ohms.
-
Additionally, check 4-pin connector terminals for short circuit to one another.
Terminal 4 and test box socket 16.
Specification: infinite ohms .
-
Set multimeter to voltage measurement range.
-
Check 4-pin connector terminals for short circuit to battery positive (B+) according to wiring diagram.
-
Terminal 2 and vehicle Ground (GND).
-
Terminal 4 and vehicle Ground (GND).
Specification: 0 volts.
If no wiring malfunction is detected:
-
Replace Mass Air Flow (MAF) sensor -G70-.
-
Read the readiness code. If DTC memory has been erased, verify repair via appropriate display group, See Readiness code, creating. See: Testing
and Inspection
