GTI V6-2792cc 2.8L DOHC (AAA) (1996)
When installing the ECM, identification label must be upward
^
Install latest version ECM
^
Ensure that plastic clip - see illustration - is properly in position
^
Tighten bolt and nut -2- and -2a- (1O NM - 7 ft lb)
^
Ignition switch on
^
Code Control Module (Scan Tool Function 07). Follow procedure in appropriate repair manual
^
Check DTC Memory (Scan Tool Function 02). Follow procedure in appropriate repair manual
^
Erase DTC memory (Scan Tool Function 05). Follow procedure in appropriate repair manual
3.
Perform Basic Setting
^
Press buttons -0- and -4- to select "Basic Setting" function 04 and press -0- button to confirm input
^
Press buttons -0-, -9- and -8- to input display 098 and press -0- to confirm input
Note:
Do not depress accelerator pedal.
^
VAG 1551 display in channel 4 will indicate adaptation completed by showing I.O."
If display does NOT show "I.O.", stop procedure at this step; find cause and repair. Begin again with "Basic Setting.7, If "I.O." continue with
next step.
^
Wait at least 30 seconds before ending basic selling then press --> button
^
Press button -0- and -6- and press -Q- button to confirm input - (end output)
^
Disconnect VAG 1551
^
Start engine and let idle until coolant temperature is above 80 degrees Centigrade
^
Reconnect VAG 1551
^
Check DTC memory (Scan Tool Function 02).
Follow procedure in appropriate repair manual
^
Set and verify readiness code - 01.29 - 01.54.
Follow procedure in appropriate repair manual