GTI V6-2792cc 2.8L DOHC (AAA) (1996)
Fig. 1 Assembling selector lever before installing
Adjust Shift lock Solenoid -N110- (Fig. 2) and carry out functional check (Fig. 3) before installing selector lever in selector lever housing.
- Install set screw and Shift lock Solenoid -N110- mounting screws with thread-locking fluid AMV 185 101 A1.
Fig. 2 Adjusting Shift lock Solenoid -N110-
- Adjust solenoid by sliding in elongated holes until correct clearance -a- exists between push rod and lever - Fig. 3.
Fig. 3 Adjusting clearance between push rod and lever
Dimension -a = 0.3 mm (0.019 in.)
Functional check
- Shift selector lever into position "P" and supply Shift lock Solenoid -N110- with 12 Volts
- It must not be possible to shift selector lever into , driving gear.
- Interrupt solenoid operation.
- It must now be possible to shift into driving gears.
- Push rod must not catch on lever.
- Shift selector lever into "N" and check as in "P".
- After adjusting clearance, install assembled selector lever.