GTI V6-2792cc 2.8L DOHC (AAA) (1996)
Test Steps And Possible Causes Continue
Use tester VAG 1466 when troubleshooting rear window wiper/washer system!
Test Conditions:
-
Fuses No. 4 and 50K!
-
Rear window wiper in end position!
Troubleshooting preparations:
-
Remove rear window wiper/washer system relay (J 30), stamped with production control number 72, from relay position 2
-
Remove wiper/washer intermittent relay (J 31) stamped with production control number 19 or 99 (depending on equipment), from relay position 8.
-
Insert test adaptor VAG 1466/3 into relay position 2.
-
Connect VAG 1466 to test adaptor.
-
Switch ignition ON.
Test procedure information:
-
Perform test steps according to table.
-
If specified value/test result is obtained, continue troubleshooting with next test step (test result OK).
-
If specified value/test result is not obtained, locate and eliminate malfunction using table.
-
Use valid wiring diagram for checking wiring.