GTI GLS L4-1.8L Turbo (AWW) (2001)
-
Remove bolts -1- and -2- and remove pendulum support.
-
Remove steering gear bolts -5-.
-
Remove stabilizer bar link nut -7
-
On TDI engines, remove exhaust system bolts -6-.
-
Place transmission jack VAG 1383A with 1359/2 under sub-frame.
-
Remove bolts -3- and -4- for sub-frame.
-
Lower sub-frame using engine/transmission Jack VAG 1383 A.
Installing
Before installing sub-frame bolts, position steering gear on sub-frame and install bolts.
Threaded sleeve -1- must seat in subframe hole.
Continue installation in reverse sequence.
-
Check steering wheel position during test drive.
-
Check front wheel toe if steering wheel is not positioned straight ahead.
Tightening torque:
Ball joint to control arm 20 Nm (15 ft. lbs.) + 90°
Use new bolts!
Pendulum support to subframe
M 10 x 70 50 Nm (37 ft. lbs.)
M 10 x 30 50 Nm (37 ft. lbs.)
Steering gear to sub-frame 20 Nm (15 ft. lbs.) + 90°
Use new bolts!
Coupling rod to stabilizer bar 30 Nm (22 ft. lbs.)