GTI GLS L4-1.8L Turbo (AWW) (2001)
Oil Filter Housing: Locations
Lubrication System Components
Lubrication system components, assembly overview
1- 15 Nm
2- Sealing flange
Must be located on alignment sleeves
Clean sealing surface before installing
Insert with silicone sealant D 176 404 A2
Removing and installing refer to Sealing Flange, Belt Pulley Side See: Cylinder Block Assembly/Sealing Flange, Engine Front/Service and
Repair
3- Chain tensioner with tensioning rail, 15 Nm
Check for wear
When installing, pretension spring and install
4- Chain sprocket
For oil pump drive
Check for wear
5- Cylinder block
Removing and installing crankshaft, refer to Crankshaft See: Cylinder Block Assembly/Crankshaft
Piston and connecting rod, disassembling and assembling, refer to Pistons and Connecting Rods, Assemby Overview See: Cylinder Block
Assembly/Piston or See: Cylinder Block Assembly/Connecting Rod
6- Oil dipstick
Oil level must not be above max. mark!
7- Inlet spout
For oil dipstick
For extracting oil