GTI GLS L4-1.8L Turbo (AWW) (2001)
/Page-418004.png)
-
Remove vibration damper/belt pulley.
-
Remove lower and middle toothed belt cover.
-
Mark direction of rotation of toothed belt.
-
Install tensioning bolt T10092 into tensioning device for toothed belt.
-
If necessary, align pressure piston before tensioning using needle nose pliers or a thin wire (hole in pressure piston and hole in housing must line
up).
-
Tension pressure piston of tensioner just enough that the pressure piston can be secured using Locking Pin T40011.
-
Remove toothed belt.
-
Turn crankshaft back slightly.
Installing
Note:
When turning camshaft, crankshaft must not be at TDC. Valves and/or pistons may be damaged.
A - Toothed belt completely removed
If toothed belt was only removed from camshaft gear
Conditions
^
The pistons must not be positioned at TDC.
Work procedure