GTI GLS L4-1.8L Turbo (AWW) (2001)
-
Pull the 3 pin connector off the diagnosis pump (V144).
-
Connect hand multimeter V.A.G 1526 A to measure resistance between the contacts 1 and 3 of -V144. Specification: 640 . . .720 Ohms.
-
Connect hand multimeter V.A.G 1526 to measure resistance between the contacts 2 and 3 of -V144. Specification: 12.5 .. .19.5 Ohms.
If the specifications are not attained:
-
Replace the diagnosis pump -V144
-
Check DTC memory:
-
Read out readiness code:
-
If the DTC memory has been erased or the engine control module separated from the permanent positive, the readiness code must be generated
again.
Checking voltage supply
Test conditions
-
Fuse No. 43 must be OK.
-
The battery voltage must be at least 11.5 V.
Test sequence
-
Remove rear right wheel housing liner: