GTI GLS L4-1.8L Turbo (AWW) (2001)
-
Always replace
12. Gear selector lever
-
Install so that the master spline aligns with selector shaft
-
Can be replaced with the selector mechanism installed
-
Installation position
13. End cover
Fig. 1 Removing ball sleeve from selector mechanism cover
-
Before pulling out ball sleeve, destroy plastic cage and remove balls.
A - Internal extractor, e.g. Kukko 21/3, 18.5 ... 23.5 mm
Fig. 2 Driving ball sleeve into selector mechanism cover
Fig. 3 Installing oil seal onto stop