Jetta L4-1.8L Turbo (AWD) (2000)
Vehicles with electrical window regulators
-
Removing motor for window regulator.
Vehicles with mechanical window regulators
-
Removing crank mechanism and transfer element for cable reel.
Continued for all vehicles
NOTE:
-
Repair using repair kit is only possible with window regulator that are equipped with eccentric relay pulley - 1 -.
-
For window regulators with relay pulleys without eccentric - 2 -, complete carrier assembly must be replaced.
-
Color of relay pulleys is not important.
-
Protect loudspeakers against damage during entire repair.
-
Place carrier assembly on a level surface, support if necessary.
-
Checking relay pulleys, guide rails and seal for damage. Replace carrier assembly if damaged.
-
Locate start and end of diagonal Bowden cable - 4 -. Do not damage diagonal Bowden cable - 4 -, this is not replaced.
-
Bowden cables - 2 - and - 6 -, which come from cable reel - 5 -, must be cut through in guide rails - 3 - and - 7 -.
-
Slide coupling plate and clamping brackets - 1 - on guide rails into topmost position. It is only possible to remove coupling plate with clamping
brackets here.