Jetta L4-1.8L Turbo (AWD) (2000)
Liftgate Window Glass: Service and Repair
Rear Window Removal and Installation
Rear Window, Assembly Overview
1
-
Rear window
2
-
Dimension a = 3 mm (0.19 in.)
3
-
Sealing lip (component part of pre-coating)
4
-
PUR adhesive sealant
-
Cross section of bead: Width = 7 mm (0.28 in.); Height = 11 mm (0.43 in.) (including pre-coating, residual material on glass and window
flange
-
Curing time See: Related Information For All Flush Bonded Windows/Curing Time
5
-
Dimension b = 6.5 mm (0.255 in.)
-
Check gap measurement with gauge 3371
6
-
Window adjuster
-
Part No. 443 845 631 A
7
-
Dimension C = 3 mm (0.19 in.)
Undamaged Rear Window, Removing
-
Disconnect wiring connections for heated rear window and press contact tabs onto window.
-
Remove hatshelf.
-
Remove upper C-pillar trim. See: Interior Moulding / Trim/Trim Panel/Service and Repair
-
Loosen sealing lip from window flange with plastic wedge and spray in cleaning solution D 009 401 04 (as a substitute for lubricant).
-
Place cutting thread with help of small tube into window flange
NOTE: Place cutting thread in deep enough so that damage to lip or spacer rib is avoided.