Jetta L4-1.8L Turbo (AWD) (2000)
/Page-1359002.png)
^
Disconnect connector -1- of Mass Air Flow MAF sensor from air filter tube
^
Remove bolts -2- at air filter -3- and move filter to left side.
^
On vehicles with Diesel engines, remove relay panel above brake booster.
^
Remove as much brake fluid as possible from brake fluid reservoir using a brake bleeder bottle.
^
Insert brake pedal depressor VAG 1869/2 or equivalent.
^
Activate brake pedal booster with brake pedal depressor.
^
Connect bleeder bottle hose to bleed screw of left front brake caliper and open bleed screw.
^
Close left front bleed screw.
^
Release ABS control module connector (arrow-1-) and remove (arrow-2-).
^
Place plastic covering under control module and hydraulic unit. Do not use rags.
Note: Do not let brake fluid enter electrical connectors.
^
Disconnect brake lines from hydraulic unit to brake master cylinder (arrows) and suspend with wire.
^
Disconnect remaining brake lines from hydraulic unit.
^
Seal brake lines and threaded holes (arrows) using plugs from repair kit, Part No. 1 HO 698 311 A.
