Jetta L4-1.8L Turbo (AWD) (2000)
Fig. 5 Pulling out starter bushing
Fig. 6 Driving in starter bushing
-
Lubricate bushing mounting before driving in.
Fig. 7 Removing and installing multifunction TR switch
Location: Multi-function TR switch is located on rear of the transmission.
-
Switch ignition off, open hood.
-
Disconnect wiring connector from multifunction TR switch.
-
Remove bolt and retainer.
-
Remove multi-function TR switch.
-
Replace seal.
Installation is performed in the reverse order of removal.
-
Insert switch so that each pin rests on a slope of detent segment.
-
Tighten bolt to 10 Nm.