Jetta L4-1.8L Turbo (AWD) (2000)
/Page-1145007.png)
-
Install support bar 10-222 A with legs 10-222 A/1 (6-cyl. engine adapter 10-222 A/3) and support engine/transmission in this position.
-
Remove bracket for power steering pressure hose.
-
Do not remove the bolts for the transmission carrier-arrows- until the transmission has been supported.
-
Remove pendulum support-arrows-.
-
Lower transmission approx. 60 mm -a-.
-
Pull black connector off sensor.
-
Remove bolt and pull sensor -1- out.
-
Replace seal.
Installation is performed in the reverse order of removal.
-
Tighten bolt to 10 Nm.
