Jetta L4-1.8L Turbo (AWD) (2000)
/Page-1245002.png)
-
Remove bolts (arrows).
-
Press axle shaft out.
NOTE:
-
When pressing axle shaft ensure sufficient clearance is available.
-
Do not allow drive axle to hang by inner CV or triple-rotor joint to avoid damaging bearing surfaces. Tie drive axle to stabilizer bar or other
suspension component if it is to remain attached to drive flange.
-
Do not flex inner CV or triple-rotor joint more than 25 degrees from its original angle.
-
Remove axle shaft.
The following sequence applies to automatic transmission vehicles only
-
Remove bolts (arrows).
-
Remove left noise insulation if equipped.
