Jetta L4-1.8L Turbo (AWD) (2000)
Seals and Gaskets: Service and Repair
Axle Flange Shaft Oil Seals Replacing
5 Speed Manual 02J
Axle Flange Shaft Oil Seals, Replacing (Transmission Installed)
-
Observe general repair instructions.
Special Tools
-
VW 771 Slide hammer
-
VW 771/37 Puller hooks
-
3106 Drift
Removing
-
Before replacing left-side oil seal:
-
Remove axle shaft. Refer to Transmission and Drivetrain.
-
Before replacing right-side oil seal:
-
Turn steering to right onto full lock stop.
-
Remove right inner constant velocity joint protective cover from engine, if installed.
-
Disconnect axle shaft from flange shaft.
-
Tie up drive shaft as high as possible. Do not damage paint on drive shaft.
-
Place drip tray underneath.
-
Remove flange shaft cone-head bolt.
-
Remove flange shaft with spring.