Jetta L4-1.8L Turbo (AWP) (2004)
-
Remove aluminum cross member from final drive.
-
Loosen multi-point socket head bolt -1 - .
-
Move final drive approximately 15 ... 20 mm (.591 ....787 inch) -arrow - .
2 - Final drive support
-
Position special tool.
1 - Washer
-
Pull out bonded rubber mounting by tightening the spindle.
Installing
Installation position of bonded rubber mounting
Arrow on bonded rubber mounting -1 - must point up or down.
-
Position special tools.
-
Pull in bonded rubber mounting by turning spindle.