Jetta L4-1.8L Turbo (AWP) (2004)
Installing
-
Installation is carried out in the reverse sequence
Observe the following points when installing:
-
When installing the brake master cylinder and brake booster, make sure that the push rod is correctly located in the brake master cylinder.
-
After installing, bleed brakes
-
Initiate basic settings
-
A zero compensation of brake pressure sender 1 -G201- and brake pressure sender 2 -G214- must be performed in addition to basic settings on
vehicles with ABS/EDL/ASR/ESP
-
After installing, bleed brakes
-
Initiate basic settings.