Jetta L4-1.8L Turbo (AWP) (2004)
-
Pull the 4 pin connector off Engine Coolant Temperature (ECT) sensor (G62) with coolant temperature gauge sender (G2) - arrow-.
-
Bridge connector contacts 3+4 using adapter cables from VAG1594 and observe display.
If display jumps to approx. 143 °C:
-
Press -> key.
-
Press keys 0 and 6 for "End data transfer" function and confirm input with Q key.
-
Switch ignition off.
-
Replace Engine Coolant Temperature (ECT) sensor (G62).
-
Check DTC Memory, if necessary, repair any malfunctions and then Erase DTC Memory,Checking and Erasing DTC Memory. Refer to
"Displaying and Reading Trouble Codes/With Manufacturer's Scan Tool/Check DTC Memory (Function 02)" See: Testing and
Inspection/Reading and Clearing Diagnostic Trouble Codes/Reading Diagnostic Trouble Codes/With Manufacturer's Scan Tool/DTC Memory
Checking and Erasing/Check DTC Memory (Function 02)
-
Read readiness code. If DTC memory has been erased or engine control module was disconnected from permanent positive, readiness code must
be generated again: Refer to "Monitors, Trips and/or Drive Cycle (Readiness Codes)/With Manufacturer's Scan Tool/Displaying and Creating
Readiness Codes/Readiness Code, Reading" See: Testing and Inspection/Monitors, Trips, Drive Cycles and Readiness Codes
Engine code AWP, Refer to "Monitors, Trips and/or Drive Cycle (Readiness Codes)/With Manufacturer's Scan Tool/Displaying and Creating
Readiness Codes/ Readiness Code, Generating" See: Testing and Inspection/Monitors, Trips, Drive Cycles and Readiness Codes
If display remains at approx. -48 °C:
-
Press -> key.
-
Press keys 0 and 6 for the "End data transfer" function and confirm input with the Q key.
-
Switch ignition off.
-
Check wiring using wiring diagram.
Continuation of check when display approx. 143 °C: