Jetta L4-1.8L Turbo (AWP) (2004)
-
Check for open circuits in wires between test box and connector according to wiring diagram.
Terminal 1 + socket 98
Terminal 2 + socket 86
Terminal 3 + socket 108
Wire resistance: max: 1.5 Ohms
-
Also check wires for short circuit to each other.
Specified value: Infinite Ohms
If no malfunctions are found in the wires and there was voltage between terminals 1 + 3:
-
Replace Camshaft Position (CMP) sensor:
-
Vehicles with engine code AWD, item 11,
-
Vehicles with engine code AWP, AWW, item 7.
-
Erase DTC memory of Engine Control Module (ECM), Diagnostic mode 4: Reset/erase diagnostic data. See: Powertrain Management/Computers
and Control Systems/Testing and Inspection/Scan Tool Testing and Procedures/With Generic Scan Tool/Diagnostic Mode 4: Reset/Erase
Diagnostic Data
-
Generate readiness code. See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Monitors, Trips, Drive Cycles and
Readiness Codes
If no malfunctions are found in wires and there was no voltage between terminals 1 + 3:
-
Replace Engine Control Module (ECM).