Jetta L4-1.8L Turbo (AWP) (2004)
/Page-1630002.png)
-
Pry seal out using a screwdriver. Do not damage selector shaft.
-
Drive in new seal until thrust piece contacts stop. Ensure that seal remains straight when driving in.
-
Install multi-function switch (F125) -3=.
-
Fit connector to multi-function switch -
-
Push lever -1- onto selector shaft.
-
Shift selector lever from "P" to "2".
-
Tighten nut -arrow- to 20 Nm.
-
Install battery carrier.
-
Install battery.
-
Reconnect Ground strap to battery.
-
Enter radio code.
