Jetta L4-1.9L DSL Turbo (BEW) (2004)
Trunk / Liftgate Lock: Service and Repair
Lock Cylinder Housing, Removing and Installing
Lock Cylinder Housing, Removing And Installing
1. VW-symbol
-
consisting of emblem carrier and message
-
To install VW symbol, remove protective foil and adhere to lock cylinder housing using two-sided adhesive tape
-
also bolted to lock cylinder housing Item -7-
2. Lock cylinder housing
-
Removing
-
Remove rear lid trim
-
Disconnect connector for micro-switch/wiring harness.
-
Remove operating rod at actuator lever.
-
Remove screws Item -6- (3x).
-
Remove lock cylinder housing with VW symbol from rear lid.
-
Installing:
-
Installation is performed in reverse order of removal.
3. Micro-switch
-
For vehicles with central locking system
-
For vehicles without central locking system
-
Allocation, See Original parts distributor
4. Linkage clip
-
To remove operating rod, disconnect linkage clip and pull open
5. Seal
-
Attached in area of lock cylinder housing
6. Bolt
-
Qty. 3
-
4 Nm
7. Bolt
-
Qty. 2