Jetta L4-1.9L DSL Turbo (BEW) (2004)
Tip
Vehicle Eligibility
^
To determine if a vehicle is eligible for the Glow Plug Limited Warranty Exension, check the VIN in ElsaWeb > Vehicle Specific Notes > Vehicle
Data. If the warranty extension is applicable to the vehicle, The "Enhanced Coverage" section of the "Vehicle Data" screen in ElsaWeb will be
populated with the warranty extension parameters.
After 28E61R8 campaign performed, vehicle exhibits a hard / no start condition when temperatures drop below freezing. This condition may be
accompanied by rough running engine at idle with no fault codes correlated.
Note
Production Solution
Not applicable.
Service
Section A - Golf, Jetta/Jetta Wagon, and New Beetle:
Installing New Glow Plugs, Glow Plug Control Module, and Engine Control Module Update - Programming (Flashing) using Software Version
Management (SVM)
Tip:
Hard / no start conditions above freezing temperatures are not related to this issue.
Step 1:
^
Remove glow plug(s) and inspect part number. If previous version NGK glow plug (N10591604; N10591608) is present, reinstall glow plug(s). This
repair solution does not apply to vehicles equipped with previous version NGK glow plugs.
^
Install glow plugs and glow plug control module from table below. Refer to direction in Elsaweb >> Repair Manual >> Engine >> Engine
Mechanical, Fuel Injection and Glow Plug >> 28 Ignition/Glow Plug System >> Removal and Installation.
Step 2: