Jetta L4-1.9L DSL Turbo (BEW) (2004)
Pressing out center of hydraulic bonded rubber bushing
-
Install special tools on rear axle as shown on illustration.
-
Pull a plastic bag over the special tools and control arm to pick up the escaping oil when pressing out the center of bonded rubber bushing.
-
Press out the center of bonded rubber bushing.
1-VAS6178
2-VAS6180/1
3-VAS6180/4 long
4-VAS6180/3
5-VAS6180/2
6-V.A.G. 1383A with V.A.G. 1359/2
Note:
^
The edges of separating device VAS6180/2 must come in position between the collar of the bonded rubber bushing and the connection of the
control arm.
^
The note "Top" on the separating device VAS6 180/2 must point to the control arm.
Pressing out sleeve of hydraulic bonded rubber bushing
-
Press out the sleeve
1-VAS6178
2-VAS6180/1
3-VAS6180/4 long
4-VAS6180/5
5-VAS6180/8
6-V.A.G. 1383A with V.A.G. 1359/2
Note: The note "Top" on the device VAS6180/8 points to the control arm.
Installing