Jetta L4-1.9L DSL Turbo (BEW) (2004)
2 - Tensioning strap T10038 . The vehicle must be fastened with the tensioning straps on left and right side.
Tightening bearing bracket is only possible, when the measured value - a - from the middle of wheel hub to lower edge bordering wheel housing is
reached.
-
Turn the wheel hub until one of the holes for the wheel bolts is at the 12 o'clock position.
-
Install support T10149 with a wheel bolt.
-
Lift wheel bearing housing using engine and transmission jack until dimension - a - is reached.
Caution:
^
Do not raise or lower the vehicle if the engine and transmission jack is under the vehicle.
^
Do not /cave engine and transmission jack under the vehicle any longer than necessary.
-
Tighten bolts from bearing bracket to rear axle with tightening torque.