volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

MIL ON - Poor Idle/Stalls, Loss of Power, Exhaust Smoke|Page 5232 > < MIL ON - Poor Idle/Stalls, Loss of Power, Exhaust Smoke|Page 5230
Page 1
background image

Instrument Panel/Dash Board: Service and Repair

-

Remove the instrument cluster. See: Instrument Cluster/Service and Repair Instrument Panel

-

Remove the right-side lower instrument panel tray where applicable by removing the screws.

-

Pry out the left, center, and right ventilation grilles from their housings, then remove the retaining screws and the housings.

-

Remove the speaker grilles and, if applicable, the speakers. 

-

Remove the grille retaining screw and slide the grille toward the rear of the car. The screw is covered by a full-length trim piece.

-

Remove the cold start handle from the cold start cable.

-

Pry out the glove box light assembly and remove its wiring connector. 

-

Remove the glove box by removing the screws around its rim.

-

Remove the drip tray from the base of the windshield in the engine compartment.

-

Remove instrument panel retaining screws (B) and (C), and retaining nuts (A). Access nuts from the engine compartment. Nuts are located in the
plenum.

MIL ON - Poor Idle/Stalls, Loss of Power, Exhaust Smoke|Page 5232 > < MIL ON - Poor Idle/Stalls, Loss of Power, Exhaust Smoke|Page 5230