Jetta L4-1588cc 1.6L DSL SOHC Turbo (1985)
1 glass 2 rubber seal 3 exterior molding 4 adhesive sealant 5 interior beading
Note
Take care not to damage paint around windshield perimeter when removing exterior molding.
-
remove exterior molding 3 and rubber seal 2 with needle nose pliers
-
with aid of helper push wire 6 through adhesive sealant 4 between glass 1 and interior beading
5.
Grab wire on outside with needle nose pliers.
-
attach ends of wire to tool VW 1351 (or use two needle nose Vise Grips (R)), so part X is inside and part Y outside car. Thread wire through in
direction of arrows and secure ends at screws A and B.