Jetta L4-2.0L (AEG) (2000)
Camshaft Oil Seal: Service and Repair
Camshaft oil seal, replacing
Hose spring sealing rings
Special tools and equipment
-
10-203 Oil seal driver
-
2085 Seal puller
-
3415 Counter support
-
VAG 1331 Torque wrench (5 to 50 Nm)
-
VAG 1332 Torque wrench (40 to 200 Nm)
-
T10071 Oil Seal Driver
PTFE sealing rings:
Special tools and equipment
-
2085 Seal puller
-
3415 Counter support
-
T10071 Oil Seal Driver
-
VAG 1331 Torque wrench (5 to 50 Nm)
-
VAG 1332 Torque wrench (40 to 200 Nm)
Removing
-
Remove toothed belt guard upper part.
-
Turn the crankshaft to bring the camshaft to TDC for cylinder 1. The marking on the camshaft gear must match up with the arrow on toothed belt
guard.
-
Loosen the tensioning roller and remove toothed belt from camshaft gear.
-
Slightly turn crankshaft back.
-
Remove the camshaft gear. To loosen the bolt, hold camshaft gear secure with Counter Support -3415-.
-
Remove woodruff key from camshaft.
-
Insert the camshaft gear mounting bolt all the way into camshaft.
-
Turn the inner part of the Seal Remover -2085- two turns (approx. 3 mm) from the outer part and secure it with a knurled-head screw.