Jetta L4-2.0L (AEG) (2000)
Control Systems/Testing and Inspection/Scan Tool Testing and Procedures/With Generic Scan Tool/Diagnostic Mode 1: Check Measured Values
-
Oxygen sensor heater for oxygen sensor before catalytic converter must be OK, check. See: Computers and Control Systems/Testing and
Inspection/Component Tests and General Diagnostics/Oxygen Sensor Before Catalyst, Aging Check
Function test (Vehicles with engine code AEG)
-
Select the oxygen sensor test results and check whether the specified values are being reached, Diagnostic mode 5: Check output of oxygen sensor
signals.
-
End diagnosis and switch ignition off.
If specified values are not obtained:
-
Check primary voltage.
Checking primary voltage
-
Unscrew protective cover (arrows) and disconnect 4-pin harness connector (black) -1- to Heated Oxygen Sensor (HO2S) -G39- before catalytic
converter.
-
Connect multimeter to terminals 3 + 4 of connector to Engine Control Module (ECM) for voltage measurement.
-
Switch on ignition and measure primary voltage. Specified value: 0.400 to 0.500 Volts
-
Switch ignition off.
If specified value is not obtained:
-
Test oxygen sensor wires.
If specified value is obtained:
-
Replace Heated Oxygen Sensor (HO2S) 1 Bank 1 -G39- before catalytic converter, item 9.
-
Erase DTC memory of Engine Control Module (ECM),Diagnostic mode 4: Reset/erase diagnostic data.
-
Generate readiness code. See: Computers and Control Systems/Testing and Inspection/Monitors, Trips, Drive Cycles and Readiness Codes
Checking oxygen sensor wires
- Connect test box to control module wiring harness, connect test box for wiring test.