Jetta L4-2.0L (AEG) (2000)
Shift Cable: Service and Repair
4 Speed Automatic 01M
Selector lever cable, removing and installing
Removing
-
Shift selector lever into "P" position.
-
Pull selector lever cable upward off lever/selector shaft -4-.
-
Raise vehicle.
-
Separate exhaust system by loosening clamping sleeve.
-
Remove tunnel heat shield front and rear.
-
Remove cover from selector lever housing.
-
Pry selector lever cable -3- off selector lever -2- with a screwdriver.
-
Pull circlip -1- for securing selector lever cable to selector lever housing out downward.
-
Pull selector cable carefully out of selector lever housing.
Installing
Note:
-
Check the protective sleeve for damage; the protective sleeve can only be changed together with the selector lever cable.
-
Before installing lightly grease ball socket on end of cable.
-
Check that the protective sleeve correctly fitted. Do not install the protective sleeve twisted.
-
Do not bend or kink the selector lever cable.
-
Selector lever and lever/selector shaft are in "P" position, front wheels are blocked.