Jetta L4-2.0L (AZG) (2004)
Trunk / Liftgate Lock Cylinder: Service and Repair
Jetta Sedan
Lock Cylinder Housing, Removing And Installing
1
-
VW-symbol
-
consisting of emblem carrier and message
-
To install VW symbol, remove protective foil and adhere to lock cylinder housing using two-sided adhesive tape
2
-
Lock cylinder housing
-
Removing
- Remove rear lid trim
- Disconnect connector for micro-switch / wiring harness.
- Remove operating rod at actuator lever.
- Remove screws (3x).
- Remove lock cylinder housing with VW symbol from rear lid.
-
Installing:
- Installation is performed in reverse order of removal.
3
-
Micro-switch
-
For vehicles with central locking system
-
For vehicles without central locking system
-
Allocation Original parts distributor
4
-
Linkage clip
-
To remove operating rod, disconnect linkage clip and pull open
5
-
Seal
-
Attached in area of lock cylinder housing
6
-
Bolt
-
Qty. 3