Jetta L4-2.0L (AZG) (2004)
11. ABS speed sensor
-
Before inserting sensor, clean mounting hole inner surface and coat with lubricating paste G 000 650
12. Hex socket head bolt 8 Nm (70 inch lbs.)
13. Hex socket head bolt, 65 Nm (48 ft. lbs.)
14. Brake carrier with guide pins and protective cap
-
Supplied as replacement part, assembled with sufficient grease on guide pins
-
If protective caps or guide pins are damaged use repair kit. Use grease packet supplied to lubricate guide pins.
15. Brake hose/brake line
-
With banjo bolt and seals
-
Banjo bolt to brake caliper tightening torque 38 Nm (28 ft. lbs.)
-
Do not disconnect brake hose when changing brake pads
16. Self-locking hex bolt, 35 Nm (26 ft. lbs.)
-
Always replace
17. Brake caliper
-
Do not disconnect brake hose when changing brake pads
-
Removing:
-
Remove brake pad -Item 18.
-
Install brake pedal depressor VAG 1869/2
-
Remove brake hose -Item 15 from brake caliper
-
Installing:
-
Install brake pads -Item 18.
-
Connect brake hose -Item 15 to brake caliper
-
Remove brake pedal depressor VAG 1869/2
-
Bleed brake system.
-
Servicing
-
Parking brake cable must be adjusted first after maintenance or replacement.
-
Adjusting parking brake
18. Brake pads
-
Thickness
-
Wear limit
-
Checking thickness:
-
Always replace both sides on an axle.
-
Removing and installing
19. Pad retaining springs
-
Replace always when changing pads
Brake pads, removing and installing
Special tools and equipment
-
3272 Resetting and removal tool