Jetta L4-2.0L (AZG) (2004)
ABS system components for rear axle, (Front wheel drive) removing and installing
1. ABS speed sensor
-
Checked by On Board Diagnostic (OBD)
-
Before inserting sensor, clean mounting hole inner surface and coat with lubricating paste G 000 650
-
Disc brakes
2. Hex socket head bolt, 8 Nm (70 inch lbs.)
3. Stub axle
4. Splash plate
5. Wheel hub with wheel bearing and rotor
-
Replace each time after removing
-
Only replace complete
-
Removing and installing
6. Self-locking 12-point nut, 175 Nm (129 ft. lbs.)
-
Replace each time after removing
7. Cap
-
Pressing off and driving in
8. Brake disc
9. Phillips-head screw
10. Hex bolt 60 Nm (44 ft. lbs.)
-
With dished spring
11. Brake drum
-
Brake drum diameter 230 mm (9.06 inch)
-
Wear limit 231 mm (9.09 inch)
-
Release adjustment before removing brake drum
-
Clean thoroughly, check for wear, damage, tolerances, damaged wheel bolt threads and perfect braking surface
12. Back plate with brake shoes
13. Axle beam
Removing and installing speed sensor on rear axle
Removing