Jetta L4-2.0L (AZG) (2004)
-
Disconnect connector -1 - .
-
Remove heat shield -1 - .
-
To do this push lip - arrow A - with a screwdriver in and push at the same time the heat shield -1 - upward in direction of arrow.
-
For vehicles with brake wear pad indicator remove bolt -arrow B - to remove support for brake wear pad indicator.
-
Remove upper hex nuts of connecting links from left and right suspension strut.
-
Pull out clamp on brake hose bracket and release brake hose.
-
Release speed sensor wiring from front suspension strut.
-
Remove brake carrier with brake caliper and hang from body with wire
Right suspension strut
Additional work is required if right suspension strut is to be removed
-
Remove noise insulation.
-
Disconnect axle shaft from transmission axle flange.
The following work sequence is valid for both sides
-
Separate wheel bearing housing/suspension strut bolted connection.