Jetta L4-2.0L (AZG) (2004)
Shift Interlock Solenoid: Service and Repair
5 Speed Automatic 09A
Shift lock solenoid -N110-, removing and installing
Removing
-
Check whether a coded radio is fitted. If so, obtain anti-theft coding.
-
Shift selector lever into "P" position.
-
Switch ignition off and disconnect battery Ground strap.
-
Raise vehicle.
-
Unbolt retainer from catalyst on subframe and pull to rear. Loosen double clip.
Note: Do not remove catalyst. Leave on subframe.
-
Remove selector lever from retainer on front heat shield.
-
Remove front tunnel heat shield.
-
-Loosen center tunnel heat shield and slide to rear.
-
Unscrew 4 nuts -arrows A-.
-
Unscrew two bolts -arrows B-.
-
Carefully slide cover with protective sleeve to front over selector lever cable.
Note: Be careful not to damage protective sleeve.
-
Unclip shift lock solenoid -N110- from retainer arrows A-.
-
Pull solenoid out of locking pawl -arrow B-.