Jetta L4-2.0L (BEV) (2004)
/Page-1647005.png)
-
Remove hydraulic unit with control module.
Removing control module from hydraulic unit.
-
Place the hydraulic unit with control module down on a clean flat surface.
-
Remove E 5 hex socket head bolt -arrows- from hydraulic pump.
CAUTION: The hydraulic pump must not be separated from the hydraulic unit.
-
For this reason, tighten the hydraulic pump with the red bracket -1- from the repair kit and two sealing plugs -2- on the hydraulic unit.
-
Separate hydraulic unit with hydraulic pump from control module by lifting carefully off joint -1-.
