Jetta L4-2.0L (BEV) (2004)
Vehicle Speed Sensor: Service and Repair
Vehicle Speed Sensor (VSS), Replacing
Recommended special tools and equipment
-
10-222A Engine support bridge with 10-222A-1 bracket for engine
-
V.A.G 1331 Torque wrench (5 to 50 Nm)
-
VAG1332 Torque wrench (40 to 200 Nm)
Requirements
-
Selector lever must be in -P- position.
-
Parking brake must be engaged.
-
Ignition switched off.
Work procedure
-
First determine whether a coded radio is installed. If so, determine anti-theft coding.
-
Switch ignition off and disconnect battery Ground (GND) strap.
-
Remove battery.
-
Remove battery holder.
-
Remove air filter.
-
Position 10-222A engine support bridge with 10-222A/1 brackets as shown and support engine/transmission in this position.
-
Remove bracket for power steering pressure line.