Jetta L4-2.0L (BEV) (2004)
Transmission Position Switch/Sensor: Service and Repair
Multi-Function Transmission Range (TR) Switch, Replacing
Multi-Function Transmission Range (TR) Switch, Replacing
Recommended special tools and equipment
-
V.A.G 1331 Torque wrench (5 to 50 Nm)
Requirements
-
Selector lever must be in -P- position.
-
Parking brake must be engaged.
-
Ignition switched off.
Removing
NOTE: Multi-function switch is located at rear on transmission.
-
Disconnect connector from multi-function switch.
-
Remove mounting bolt and retainer.
-
Remove Multi-Function Transmission Range (TR) switch.
-
Replace O-ring.
Installing
Installation is performed in reverse order of removal.
-
Tighten bolt to 10 Nm.
-
Erase DTC memory of Transmission Control Module (TCM), Diagnostic mode 4: Reset/erase diagnostic data.
-
Generate readiness code.