Jetta L4-2.0L (BEV) (2004)
![background image](/volkswagen/jetta/l4-2.0l_(bev)/Page-9001.png)
Global Positioning System Module: Service and Repair
Telematic Control Module -J499-, Reconfiguring
Telematic Control Module -J499-, Reconfiguring
After replacing the Telephone/Telematic Control Module, the control module must be coded and OnStar(R) system needs to be reconfigured as
described below. Have the VIN and customer details on hand.
Special tools, testers and auxiliary items needed
-
VAS 5051 Vehicle Diagnostic Testing and Information System
-
Cable adapter VAS 5051/5a or VAS 5051/6a
NOTE:
-
DO NOT exchange Telephone/Telematic Control Modules between vehicles! Each module contains specific Station Identification (STID) and
Electronic Serial Number (ESN) data unique to the VIN. This data is used by OnStar(R) and National Cellular Telephone Network to identify the
vehicle and administer the customer's account.
-
Failure to reconfigure the control module after replacement will prevent OnStar(R) services and features from functioning, and will result in a
customer return for repair.
Prerequisite
-
Telematics control module is coded.
-
Where applicable, carefully record the 8 character Station Identification (STID) number and Electronic Serial Number (ESN) from labels on
replacement module.
-
Connect VAS 5051 with adapter cable to Data Link Connector (DLC) and select mode "Guided Fault Finding"
-
Enter appropriate model, equipment and model year information and press ">" to confirm.
After all Control Modules have been registered and DTC memories checked, see "Continued for all".
If the STID number and ESN DO NOT appear on labels on the new control module, proceed as follows:
-
Select "Go to"
-
Select "Function/Component Selection"
-
Select "Body"
-
Select "Electrical System"
-
Select "01-Systems capable of self-diagnosis"
-
Select "Telematics NAR"
-
Select "Functions - Telematics NAR" and press ">" to confirm.
-
Select "Check control module versions - Telematics NAR".
-
Record ESN and STID number from appropriate display fields.
Continued for all:
-
Select "Go to"
-
Select "Function/Component Selection"
-
Select "Body"
-
Select "Electrical System"
-
Select "01-Systems capable of self-diagnosis"
-
Select "Telematics NAR"
-
Select "Functions - Telematics NAR" and press ">" to confirm.
-
Select "check/erase DTC memory Telematics NAR"
-
Switch off ignition and wait a few moments.
-
Switch on ignition.