Jetta L4-2.0L (BEV) (2004)
-
Close off the pressure line with a plastic bag or similar.
-
Remove hex bolts -1 - and - 2 - .
-
Take out pump.
Installing
-
Fill the pump with hydraulic fluid.
-
Fill pump with fluid through intake line.
-
Turn hub by hand until oil comes from pressure side.
-
Install power steering pump on bracket and tighten bolts to 25 Nm (18 ft. lbs.).
-
Install intake hose and spring-type clip.
-
The mark - arrow A - must align with casting seam - arrow -
-
The spring-type clip must close off mark - arrow B - .
-
Install new sealing rings onto banjo bolt.
-
Tighten banjo bolt to 38 Nm (28 ft. lbs.). Installation is continued in reverse sequence