Jetta L4-2.0L (BEV) (2004)
-
Measure dimension - a - from the center of the wheel to the lower edge of the wheel housing.
-
Make a note of the measurement. This is necessary to tighten the bolts for the rear axle to the bearing bracket.
-
Install brake pedal loading device V.A.G. 1869/2 .
-
Lift vehicle on lifting platform.
-
Remove wheels.
-
Separate brake lines - arrow A - and remove clip.
-
Remove left brake hose from bracket - 2 - .
-
Remove right brake hose from rear axle.
-
Remove parking brake cable from brackets - arrow B - .
-
Place engine/transmission jack V.A.G. 1 383A under.
-
Remove bolt - 1 - for bearing bracket on rear axle on both sides.
-
Lower rear axle using engine and transmission jack V.A.G. 1 383A .
-
Tighten rear axle with tensioning strap T10038 over mounting from muffler system.
Vehicles with automatic headlight range control
-
Removing coupling rod from Left Rear Level Control System Sensor G76 from rear axle.
Continued for all vehicles
Note: Place engine/transmission jack V.A. G1383A with universal transmission support V.A.G. 1359/2 under the control arm (danger of accident
from falling parts when pulling out the wheel hub and the wheel bearing).