Jetta L4-2.0L (BEV) (2004)
/Page-1878008.png)
2 - T1 0001/8
3 - T10001/11
4 - T1 0001/5
5 - Spring tensioner V.A.G. 1752/1
6 - Bracket V.A.G. 1752/4
Caution: First compress the spring until the upper spring plate is no longer under load.
-
Make sure that the coil spring is properly seated in spring holder V.A.G. 1752/4 - arrow - .
Installing coil spring
-
Install coil spring using spring compressor V.A.G. 1752/1 onto lower spring support.
-
The end of the coil spring must lie against stop - arrow -.
-
Tighten new hex nut on piston rod.
-
Release spring compressor V.A.G. 1752/1 and remove from coil spring.
-
Install suspension strut.
Fastener/location Tightening torques:
Hex nut for upper shock absorber mounting Use new nut! ............................................................................................................ 60 Nm (44 ft. lbs.)
Front Suspension Strut, Assembly Overview
III - Front suspension strut, assembly overview
